Survival Tips

Here are three suggestions repeated from earlier sections of the manual, that are useful to remember when learning circuit editing in Log:

1. Select Exit from Misc to exit LOG.
2. If you get lost and confused, press Control-C until you know where you are.
3. The single most common mistake in LOG is to stick two gates, e.g. a capacitor and a ground, so close together that they look connected but their red dots pass through each other. The gates are NOT connected, and the circuit will NOT simulate correctly. The solution is to nudge the gates apart a bit, then refresh the screen (space bar) to make sure the red dots are aligned.

• To return to Table of Contents.